Lynx-studio Hilo Reference A/D D/A Converter System - Owner� Manuel d'utilisateur télécharger pdf (Page 37)

Page 33

3.4.8.7 Selecting Monitor Sources

Let’s look at the process of assigning input sources to Hilo’s Outputs

Let’s say that we wanted to add Digital In as a source to route to

the Line Out.

We could simply enable the Digital In with either a single-tap or

double-tap and the page would now look like this.

In this state, audio streaming from USB Play 1&2 will be merged with audio streaming from the Digital Input. One

must be cautious of the levels of each source in this case, as the combined signal strength could cause clipping to the

output. If this occurs, it can be remedied by attenuating the faders for the input sources (USB Play 1&2 and Digital In),

or by attenuating the associated output.

Now if we wish to listen to the Digital In signal through Line

Out but NOT the USB Play 1&2 signal, we could turn the USB

Play 1&2 button off, again via the one-tap, or two-tap method.

Using either method, the result would be Digital In as the only

source feeding Line Out. It would look like this.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Pas de commentaire

Lynx-studio Hilo Reference A/D D/A Converter System - Owner� Manuel d'utilisateur Page 37